1 October 2023

Elevation Transfer of Steam Turbine | Turbine Fundamentals and Basics | Basic Aspects of Steam Turbine Maintenance | Part#3 | Content-15|

Rate this post


  • It is the measurement taken between the two mating parts which are themselves assembled in two halves.
  • This is taken to ensure proper fitting of the components so that there is no fouling among themselves.
  • This measurement is taken by Height Gauge at the parting plane on both the sides.


After the centering activity is over we can start Elevation Transfer in the TOP Internals and can also start the Seal fin cutting of the Inter stage and Gland sealing of the Bottom Internals.


Leave a Reply

Your email address will not be published. Required fields are marked *